CREATING THE PAPER MAKING BOX!!!
1. Hammer in one nail in each corner on the upper frame block (which measures 7 inches as the length).
2. The nail should be like this.
3. The nail is penetrated through the wood about 1 millimeter. 4. All nails are in their corners.
5. Take the side block (longer piece) and hold it under the 7 inch piece (with the nails).
7. Flip it over and do the same as with the short piece of wood. - And this will complete the top half of the box! 6. Hammer the nails right into the side block. Repeat the step for the other side.
8. And now, we do the same for the bottom half.
9. Repeat the similar instructions from the beginning. 10. Nail it in!
11. The two frames should look like this.
12. Put the fine mesh screen ontop of the base wooden block.
13. Hammer in the U-nails on each corner.
14. Put the hinge between the two halves and screw in the screws in each of the four holes. 15. Screw in the Hook and put in the eyelet.
16. Do the same for the other base. 17. Twist it in until its firm enough and.. now you've created a paper-making box!
Click here for the procedures in making a box!

Click here to go back to home.